This system gives you Flexibility, Versatility & Repeatability
Side Clamping - By using the Fixed jaw and the Moving jaw, part sizes ranging from 25mm to the maximum length of the rails can be clamped. Once the part is less than 25mm square smaller jaws are available. A work rest can be positioned to get the job on Z zero Machine table), for fine adjustment there are 4 jackng screws that can ensure the component is perfectly level.
The kit is supplied with riser plates to eleiminate the risk of collision by raising the rails 4mm above the table, thus clearing the Z supports.
Reference buttons that are matched in length can be set as stops for production part work, so X & Y datums can be repeated.
Top clamping - Using the clamps and the Z plates it is possible to clamp conventionally. As work pieces get heavier the 4 jacjong screws will compensate for any deflection in the rails. As with the side clamping the parts can be on Z zero (Machine table) or 4mm above Z zero.
Clamping directly on the rails - Parts can be clamped directly on the rails either on the top or on the side. As they span the machine this can be quite useful for large parts.
Minimise material wasteage by being able to cut close to the edges of the block
Contact us today with any questions you may have or for a quote, we will be happy to discuss your requirements.